Panasonic KX-TCD951EB Manuel D’Utilisation
16
To select the receiver volume
3 levels (HIGH, MEDIUM, LOW) are available.
The factory preset is MEDIUM.
The factory preset is MEDIUM.
While talking, press
F
or
G
to select the
desired level.
•
After a few seconds, the display will return to
the length of call.
the length of call.
OR
In the stand-by mode, proceed as follows.
1
Press .
2
Press
G or F until “
F6
” is displayed,
then press
.
•
The current level is displayed.
3
Press
F
or
G
to select the desired
level.
4
Press .
PROG
OK
PROG
To dial after confirming the
entered number
entered number
1
Enter a phone number.
•
The entered number is displayed.
•
If you misdial, press
. Digits are
erased from the right.
•
To cancel, press
firmly.
•
If your line has rotary or pulse service, any
access numbers entered after pressing
will not be included when dialling.
access numbers entered after pressing
will not be included when dialling.
2
Press .
•
After a few seconds, the display will start
showing the length of the call.
showing the length of the call.
3
To hang up, press
or place the
handset on the base unit.
•
The handset will return to the stand-by
mode.
mode.
C
C
Making Calls
1
Press .
2
Dial a phone number.
•
The dialled number is displayed.
•
After a few seconds, the display will start
showing the length of the call.
showing the length of the call.
•
If “ ” flashes and an alarm tone sounds
after pressing
after pressing
, move closer to the
base unit. Then try again.
•
You can choose whether to display the length
of the call or phone number in the talk mode
by programming (p. 28).
of the call or phone number in the talk mode
by programming (p. 28).
3
To hang up, press
or place the
handset on the base unit.
•
The handset will return to the stand-by
mode.
mode.
Ex. LOW is selected.
Make sure that the power is ON (p. 12).
i2345678
8888
00-00-00
F6
Ex. LOW is selected.
KX-TCD951EB(016~021) 99.6.16 7:09 PM Page 16