Daewoo DTZ-29U7/U3 Manuel D’Utilisation

Page de 85
CP-520/520A/520F Service Manual 
 
DTV R&D Europe
 
35
 
5.2  FUNCTIONAL DESCRIPTION OF VIDEO PROCESSOR 
5.2.1  Vision IF amplifier 
The vision IF amplifier can demodulate signals with positive and megative modulation. The PLL 
demodulator is completely alignment-free. 
 
The VCO of the PLL circuit is internal and the grequency is fixed to the required value by using 
the clock ftequency of the TCG u-Controller as a reference. The setting of the various 
frequencies (e.g. 38, 38.9, 45.75 and 58.75MHz) can be made via the control bits IFA-IFC in 
subaddress 2FH. Because of the internal VCO the IF circuit has a high immunity to EMC 
interferences. 
 
The output of the AFC detector can be read from output byte o4H and has a resolution of 
7bit(25kHz per step). By means of this information a fast tuning algorithm can be designed. 
 
The IC contains a group delay correction circuit which can be switched between the BG and a 
uncompensated group delay response characteristic. This hasthe advantage that in multi-
standard receivers no compromise has to be made for the choice of the SAW filter. This group 
delay corection is realised for the demodulated CVBS output signal. The IC contains in addition a 
sound trap circuit with a switchable centre frequency. 
 
5.2.2  QSS sound circuit 
The sound IF amplifier is similar to the vision IF amplifier and has an external AGC decoupling 
capacitor. 
 
ThesinglereferenceQSSmixerisrealisedbyamultiplier. In this multiplier the SIF signal is converted 
to the intercarrier frequency by mixing it with the regenerated picture carrier from the VCO. The 
mixer output signal is suppliedtotheoutputviaahigh-passfilterforattenuation of the residual video 
signals. With this system a high performance hi-fi stereo sound processing can be achieved. 
 
TheAMsounddemodulatorisrealisedbyamultiplier.The modulated sound IF signal is multiplied in 
phase with the limited SIF signal. The demodulator output signal is supplied to the output via a 
low-pass filter for attenuation of the carrier harmonics. 
 
SwitchingbetweentheQSSoutputandAMoutputismade by means of the AM bit in subaddress 33H. 
 
5.2.3  FM demodulator 
TheFMdemodulatorisrealisedasnarrow-bandPLL with internal loop filter, which provides the 
necessary selectivity without using an external band-pass filter. To obtain a good selectivity a 
linear phase detector and a constant input signal amplitude are required. For this reason the 
intercarrier signal is internally supplied to the demodulator via a gain controlled amplifier and 
AGC circuit. To improve the selectivity an internal bandpass filter is connected in front of the PLL 
circuit. 
 
The nominal frequency of the demodulator is tuned to the required frequency (4.5/5.5/6.0/6.5 
MHz) by means of a calibration circuit which uses the clock frequency of the TCG(1)-Controller 
as a reference. It is also possible to frequencies of 4.72 and 5.74Mhz so that a second sound 
channel can be demodulated. In the latter application an external bandpass filter has to be