Beko DCU 6130S Manuel D’Utilisation
21 EN
A
Condensed water is not drinkable!
A
Never take out the water tank when the
programme is running!
If you forget to drain the water tank, your
dryer will stop during the following drying
cycles when the water tank is full and the
“Water tank” warning light will turn on. If
this is the case, press the “Start/Pause/
Cancel” button to resume the drying cycle
after draining the water tank.
dryer will stop during the following drying
cycles when the water tank is full and the
“Water tank” warning light will turn on. If
this is the case, press the “Start/Pause/
Cancel” button to resume the drying cycle
after draining the water tank.
To drain the water tank:
1. Drain the water as shown on the picturre .
1. Drain the water as shown on the picturre .
2. If there is lint accumulation in the water
tank cover, clean it and press to close.
3. Place the water tank into its seat.
For the condenser
Hot and humid air in the condenser is cooled
with the cold air from the room. Thus, the humid
air circulating in your dryer is condensed and
then pumped into the tank.
with the cold air from the room. Thus, the humid
air circulating in your dryer is condensed and
then pumped into the tank.
C
Clean the condenser after every 30 drying
cycles or once a month.
To clean the condenser:
1. If a drying process has been carried out,
1. If a drying process has been carried out,
open the door of the machine and wait
until it cools down.
until it cools down.
2. Unlock the 2 condenser locks after opening
the kick plate.
3. Pull out the condenser.