Epson 3010 Manuel D’Utilisation
Setting Up the Projector
19
For best results, connect your video equipment to the
HDMI
port, if possible. If your
equipment doesn’t support HDMI, connect it to either the
Component
(for high quality,
component video) or
Video
(for composite video) port.
When you connect an HDMI cable to the projector, it is recommended that you fasten it
with the included cable clip. Follow these steps to install the cable clip:
with the included cable clip. Follow these steps to install the cable clip:
1. Connect the HDMI cable to one of the HDMI ports on the projector.
2. Insert the end of the cable clip anchor into the cable clip hole near the HDMI port, as
show below.
3. Place the open cable clip around the HDMI cable, but don’t lock it into place.
4. Slide the cable clip towards the projector and lock the clip onto the HDMI connector.
To remove the cable clip, unlock the clip and disconnect the HDMI cable. Then pinch the
side of the cable clip anchor and carefully pull it out of the cable clip hole.
side of the cable clip anchor and carefully pull it out of the cable clip hole.
PC
—
Use a Mini D-sub, 15-pin monitor cable
to connect to a computer RGB
(monitor) port:
to connect to a computer RGB
(monitor) port:
For audio, use a stereo RCA to
mini-jack stereo (3.5 mm) audio cable:
mini-jack stereo (3.5 mm) audio cable:
Video
Use an RCA video and audio cable:
—
Port name
Video equipment connection
Computer connection
pl3010_3010e_UG.book Page 19 Wednesday, September 7, 2011 6:28 PM