3D Connexion 7300 Manuel D’Utilisation

Your printer and the recommended consumable supplies have been designed and tested to meet strict 
safety requirements. Attention to the following notes will ensure the continued safe operation of your 
printer.

■

Use the power cord supplied with your printer.

■

Do not use a ground adapter plug to connect the printer to a power source receptacle that lacks a 
ground connection terminal.

■

Plug the power cord directly into a properly grounded electrical outlet. Do not use an extension 
cord. If you do not know whether an outlet is grounded, ask an electrician to check the outlet.

Avoid the potential of electrical shock by ensuring that the printer is properly grounded.

■

Do not place the printer where people may step on the power cord.

■

Do not place objects on the power cord.

■

Do not obstruct the ventilation openings. These openings are provided to prevent overheating of 
the printer.

Do not push objects into slots or openings on the printer. Making contact with a voltage point 
or shorting out a part could result in fire or electrical shock.

■

If you notice unusual noises or odors, switch off the printer power immediately. Disconnect the 
power cord from the electrical outlet. Call an authorized service representative to correct the 
problem.

■

The power cord is attached to the printer as a plug-in device at the back of the printer. In the event 
it is necessary to remove all electrical power from the printer, disconnect the power cord from the 
power receptacle.

Electrical products may be hazardous if misused. 

For your protection, do not disable any internal safety locks or sensors.

Leaving the printer on is recommended for optimum performance, and does not pose a safety 
hazard.