Cobra Electronics PR 255 VP Manuel D’Utilisation

Operation

Customer Assistance

Warranty

Your microTALK

®

radio will give you years of trouble-free service 

if cared for properly. Handle the radio gently. Keep the radio away
from dust. Never put the radio in water or in a damp place. Avoid
exposure to extreme temperatures.

To install or replace batteries:
1. Remove belt clip by releasing belt clip 

latch and sliding clip up.

2. Pull up on the battery door latch to 

remove the battery compartment cover.

3. Insert the supplied four (4) AAA rechargeable

batteries (also works with non-rechargeable
alkaline batteries). Position batteries
according to polarity markings.

4. Replace battery compartment cover and 

belt clip.

1. Check to see that the batteries have been

inserted properly. See above for battery
installation instructions.

2. Insert round connector of wall charger/adapter into the charge jack

located at the top of the radio. The wall charger/adapter has two 
round connectors which enables you to charge either one or two
radios at a time.

3. Plug the wall charger/adapter into electrical outlet.

It normally takes 15 hours to fully recharge batteries. It is not
recommended to recharge batteries more than 24 hours. Estimated
operation time on a full charge is 8 hours.

Use only the supplied rechargeable batteries and wall charger/adapter
for recharging your Cobra microTALK

®

radio. Non-rechargeable alkaline

batteries can also be used.

g  Comes Close to a Cobra

®

9508-PR255-2VP-D-FinalC #17  3/29/06  3:36 PM  Page 1