AT&T feature module 2 Manuel D’Utilisation

Touch  Message  and go on to another procedure, or leave administration

mode.

Next, you assign the Loudspeaker Page feature to a line button at individual
consoles or voice terminals. Label the button(s) and follow the procedure for
assigning lines in a square, behind-switch, or pooled system. (See the “Line
Assignments” entry for your system type.)

If the system administrator has assigned your voice terminal a Loudspeaker
Page button, you can use the feature to page people or to make
announcements.

Touch  Loudspeaker Page.

If you have a multizoned paging system, wait for the dial tone, then dial

the number for the page zone you want. (These zone numbers are a

function of the paging system, not the MERLIN II system.)

Lift your handset and make your announcement.

Hang up.

You can use a Manual Signaling button to generate a beep at a co-worker’s
voice terminal. Program a Manual Signaling button for each person you want
to signal.

● 

You can signal

an outside call

someone with a Manual Signaling button while you have

in progress.

● 

The beep sounds at your co-worker’s voice terminal even if it is busy.

● 

If you program this feature on a button with lights, the green light next to

the button goes on when your co-worker
uses the Do Not Disturb feature.

● 

You  cannot  have both a Manual Signaling

button for the same person. If you try to
the feature that you programmed earlier.

To program a Manual Signaling button, label
these steps:

Enter programming mode.

Touch the button you want to program.

Dial *60 plus the intercom number of the

Leave programming mode.

uses his or her voice terminal or

button  and  an Auto Intercom

program both, you deactivate

an available button and follow

person you are signaling.

2-106  MERLIN II System Features