Binatone 950 Manuel D’Utilisation

a. Pull the Belt Clip latch up
(away from the Action 950)   

b.   While pulling the Belt Clip   
latch,slide the Belt Clip up as  
shown in Figure1. 

 

Belt Clip latch

Figure 1

Figure 2

a.  Slide the Belt Clip into the   
slot as shown in Figure2.   

  A “click” indicates the Belt   

Clip is locked into position. 

Figure 3

Figure 4

a.   Unclip the battery cover latch at the bottom of the cover, and lift  

the battery cover off.

                                                   

When placing the Action 950 in the charger, use only the power 

Don’t try to recharge non-rechargeable batteries. 

place when you are charging the batteries. 

the environment- never try to burn them or put them anywhere they 

could get burnt or punctured. 

They might leak if you do. 

a.  Insert the small plug on the end of the mains adaptor into the 

          Power-in Connection Jack at the back of the desktop charger. 

b.  Plug the mains adaptor into a 240V AC, 50Hz main socket with 

          the switch on the socket set to OFF. 

c.  Switch ON the mains socket. 

Using any other adaptor will result in non-compliance with 
EN60950-1 and will invalidate any approvals & warranty. 

 Insert the 4 “AAA” size rechargeable batteries by following the 

 Replace the Battery Compartment Cover. See Figure 4.

+ 

 /- polarity marking inside the Battery Compartment as shown in 

         Figure 3.

Use only the mains adaptor provided.