Invacare 1145547 Manuel D’Utilisation

For more information regarding Invacare products, parts, and services,

please visit www.invacare.com

Natural-Fit Handrims

Part Numbers: 1145545, 1145546, 1145547, 1145548, 1145549,
1145550, 1145551, 1145552, 1145553, 1145554

NOTE: Check all parts for shipping damage. In case of shipping damage, DO NOT use. Contact
Invacare for further instruction.

Safety Summary

To ensure the safe and proper installation of the handrims, these instructions MUST

followed:

WARNING

DO NOT install this equipment without first reading and understanding this

instruction sheet. If you are unable to understand the warnings, cautions and

instructions, contact Invacare, before attempting to install this equipment -

otherwise, injury or damage may occur.
Invacare products are specifically designed and manufactured for use in conjunction

with Invacare accessories. Accessories designed by other manufacturers have not

been tested by Invacare and are not recommended for use with Invacare products.

INSTALLATION WARNING

This procedure MUST be performed by a qualified technician.
After any adjustments, repair or service and before use, make sure that all attaching

component parts are secure.
Proper installation is critical to the performance of the handrim.

Removing/Installing Handrims with Rivnuts

NOTE: For this procedure, refer to FIGURE 1 on page 2.

Tool Needed:

• Phillips

head screwdriver

1. Remove the wheel from the wheelchair. Refer to the wheelchair owner’s manual.

2. Remove the mounting screws that secure the existing handrim to the wheel.

3. Place the Natural Fit handrim on a flat surface with the rivnuts facing up.

4. Place the thumb guard on top of the handrim.

NOTE: The thumb guard is installed on the outside of the wheelchair with wider edge making
contact with the wheel.

5. Place the wheel on top of the thumb guard and handrim.

NOTE: The outside of the wheel should be facing down.

Assembly and Installation Instructions