Invacare LYNX LX-3 Manuel D’Utilisation
Invacare Scooters
26
Part No. 1090132 Rev F
BATTERIES/CHARGING
PROCEDURE 4
BATTERIES/CHARGING
This Procedure Includes the Following:
Removing/Installing the Batteries with Cables
Replacing the Batteries
Charging the Batteries
Removing/Installing the Batteries with Cables
Replacing the Batteries
Charging the Batteries
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise, injury or damage may
result.
REMOVING/INSTALLING THE BATTERIES WITH CABLES
(FIGURE 1)
NOTE: To install batteries, reverse the following procedure.
NOTE: When removing/installing batteries keep all foreign objects, especially metal, clear of battery terminals.
NOTE: When removing/installing batteries keep all foreign objects, especially metal, clear of battery terminals.
REMOVING
WARNING
Turn Power OFF and remove key from ignition.
Where applicable, ALWAYS use a battery lifting strap when moving a battery.
Where applicable, ALWAYS use a battery lifting strap when moving a battery.
It is the most convenient method. It also helps to prolong the life of the bat-
tery.
DO NOT tip the batteries. Keep the batteries in an upright position.
The use of rubber gloves and chemical goggles is recommended when
DO NOT tip the batteries. Keep the batteries in an upright position.
The use of rubber gloves and chemical goggles is recommended when
working with batteries.
FIGURE 1 - REMOVING/INSTALLING THE BATTERIES WITH CABLES
NOTE: Hardware is in included with batteries.
NOTE: Only Model LYNX SX-3 battery cable assemblies shown for clarity.
NOTE: Only Model LYNX SX-3 battery cable assemblies shown for clarity.
Rear
Sub-Frame
Top Battery
Fastening Strap
Retaining
Ring
Battery
Lifting Strap
Battery Wiring Harness
Controller
Wiring
Harness
Red Connector
Black
Connector
Red
Connector
Black
Connector
Rear
Sub-Frame
Batteries
1. Turn Power OFF and remove key from ignition.
2. Remove the seat from the scooter. Refer to REMOVING/INSTALLING THE SEAT
2. Remove the seat from the scooter. Refer to REMOVING/INSTALLING THE SEAT
in PROCEDURE 5 in this manual.
3. Remove the rear shroud. Refer to REMOVING/INSTALLING THE REAR SHROUD
in PROCEDURE 9 in this manual.
4. Disconnect top battery fastening strap and pull through retaining ring.