Invacare 2226 Fascicule

Lug Bolt

4

Locknut (fine thread)

4

Machine Screw

2

Locknut (coarse thread)

2

Anti-Tipper Triangular Assembly

2

Washer

4

Anti-Tipper Arm w/Bracket Clamps

2

NOTE: Refer to the INSTALLATION WARNINGS in
the SAFETY SUMMARY of this instruction sheet.

1. Remove the locknuts and the lug bolts from the anti-

tipper bracket clamps.

2. Position the anti-tipper bracket clamp over the wheel-

chair frame behind the front caster as shown in FIG-
URE 1.

NOTE: Position the anti-tipper arm on the outside of
the wheelchair as shown in FIGURE 1.

3. Squeeze bracket clamps together and insert the bolts.

4. Install the locknuts onto the lug bolts. Tighten securely.

5. Repeat  STEPS 1-4 on the opposite side of the

wheelchair for the remaining anti-tipper.

6. Measure from the floor to the bottom of the wheels of

the triangular assembly.

7. Perform one (1) of the following:

TRIANGULAR ASSEMBLY 3/4-INCH FROM
FLOOR - Repeat STEPS 1-2 for the opposite tri-
angular assembly.

TRIANGULAR ASSEMBLY NOT 3/4-INCH
FROM FLOOR - Adjust the height of the triangular
assemblies. Refer to ADJUSTING FRONT ANTI-TIP-
PERS in this instruction sheet.

The Front Anti-Tippers Kit (Right and Left)
consists of:

NOTE: Check ALL parts for shipping damage. In case of
shipping damage, DO NOT use. Contact Carrier/Dealer
for further instruction.

The following recommendations are made for safe in-
stallation and adjustment of the Front Anti-tippers: