Pride Mobility Victory 9 Manuel D’Utilisation
Victory Series
www.pridemobility.com
37
Any electromechanical device occasionally requires some troubleshooting. However, most of the prob-
lems that may arise can usually be solved with a bit of thought and common sense. Many of these problems
occur because the batteries are not fully charged or because the batteries are worn down and can no longer
hold a charge.
lems that may arise can usually be solved with a bit of thought and common sense. Many of these problems
occur because the batteries are not fully charged or because the batteries are worn down and can no longer
hold a charge.
DIAGNOSTIC FAULT CODES
The diagnostic fault codes for your scooter are designed to help you perform basic troubleshooting quickly
and easily. The scooter will either display a diagnostic flash code or emit a beep code in the event one of
the conditions listed below develops.
The diagnostic fault codes for your scooter are designed to help you perform basic troubleshooting quickly
and easily. The scooter will either display a diagnostic flash code or emit a beep code in the event one of
the conditions listed below develops.
NOTE: Your scooter will not run unless the fault code condition is resolved and the scooter has been
turned off, then turned back on.
turned off, then turned back on.
What if all the systems on my scooter seem to be dead?
Make certain that the key is in the “on” position.
Check that the batteries are fully charged.
Push in the main circuit breaker reset button. See III. “Your Scooter.”
Make certain that both battery harnesses and the front-to-rear harness are firmly connected. See VII.
“Disassembly and Assembly.”
Be sure the power down timer feature has not been activated. See V. “Operation.”
Check that the batteries are fully charged.
Push in the main circuit breaker reset button. See III. “Your Scooter.”
Make certain that both battery harnesses and the front-to-rear harness are firmly connected. See VII.
“Disassembly and Assembly.”
Be sure the power down timer feature has not been activated. See V. “Operation.”
FAULT CODE
CONDITION
SOLUTION
(1)
Battery charge is low.
Charge batteries as soon as possible.
(2)
Battery charge is too low.
Charge batteries.
(3)
The scooter's battery voltage is too
high to operate the scooter, or the
charger is still connected to the off-
board charger port.
high to operate the scooter, or the
charger is still connected to the off-
board charger port.
Unplug charger and/or turn key off,
then back on again.
then back on again.
(4)
Current limit time out.
Turn the scooter off for a few min-
utes, then turn your scooter back on.
utes, then turn your scooter back on.
(5)
The manual freewheel lever is in the
(forward) freewheel position.
(forward) freewheel position.
Remove the key from the key
switch, then push the manual free-
wheel lever to the drive (rearward)
position and restart your scooter.
switch, then push the manual free-
wheel lever to the drive (rearward)
position and restart your scooter.
(6)
Throttle control lever not at center
position at start up.
position at start up.
Return the throttle control lever to
center position, turn scooter off then
back on.
center position, turn scooter off then
back on.
(7)
Speed pot error.
Call your authorized Pride Provider
for assistance.
for assistance.
(8)
Motor volts error.
Call your authorized Pride Provider
for assistance.
for assistance.
(9)
Other internal errors.
Call your authorized Pride Provider
for assistance.
for assistance.
V I I I . B A S I C T R O U B L E S H O O T I N G