Plantronics WG201/B Manuel D’Utilisation

Plantronics Voyager PRO UC User Guide 

10

The headset and USB adapter are supplied paired to each other. 
However, if you wish to use a replacement headset with your 
existing USB adapter, the units can be paired to each other by the 
following method:

flashes red and blue. The headset is now in pairing mode.

 If you don’t see the red and blue flash, press and hold the 

power button to turn your headset off.  Then press and hold the 
power button again until you see the red and blue flash.

and holding the pairing button on the adapter for two 
seconds. The pairing light will flash red and blue.

blue, the headset and the USB adapter are paired. 

 Take caution pairing the USB adapter. Do not press hard. 

Please “press” with both fingers rather than push on the USB 
adapter to avoid damage to the USB adapter or USB port.

Red Flashes

   Battery Level

S

 

More than 2/3 full

S S

1/3 to 2/3 full

S S S

Less than 1/3 full

If you are on a call you will hear the audio degrade as you move 
out of range. 

If you stay out of range, active calls will be suspended. Calls will 
be re-established upon walking back into range. 

To check the battery status, the headset must be powered on. 
Short press the power button. The indicator light flashes red to 
show the battery charge level as shown below.

When the battery charge is very low, a tone and voice prompt in 
English will automatically occur. See below. 

Battery Level

Tone

Voice Prompt

30 minutes of talk 
time remaining  
(this alert only occurs 
during an active call) 

Double high tone 
every 15 minutes

“Battery Low” 
repeats every  
30 minutes

10 minutes of talk 
time remaining 

Triple high tone 
every 30 seconds

“Recharge Battery” 
repeats every 3 
minutes