Manuel D’UtilisationTable des matières1.1 Before you Proceed121.2 Motherboard Overview131.2.1 Placement Direction131.2.2 Screw Holes131.3 Motherboard Layout141.3.1 Layout Content List151.4 Expansion Slots171.4.1 Installing an Expansion Card171. Before installing the expansion card, read the documentation that came with it and make the necessary hardware settings for the card.172. Remove the system unit cover (if your motherboard is already installed in a chassis).173. Remove the bracket opposite the slot that you intend to use. Keep the screw for later use.171.4.2 Configuring an Expansion Card171.5 Jumpers181.5.1 Clear CMOS (J3)181. Turn OFF the computer and unplug the power cord.182. Remove the onboard battery.183. Move the jumper cap from pins 1-2 (default) to pins 2-3. Keep the cap on pins 2-3 for about 5~10 seconds, then move the cap back to pins 1-2.184. Re-install the battery.185. Plug the power cord and turn ON the computer.186. Hold down the <Del> key during the boot process and enter BIOS setup to re-enter data.181.5.2 LCD Backlight Brightness Adjustment Connector (LCDPJ1)191.5.3 COM1/COM2 RI/+5V Selection (COMAJ1, COMBJ1)191.5.4 COM1/COM2 +5V/+12V Selection (COMAPJ1, COMBPJ1)191.6 Connectors201.6.1 Rear Panel Connectors20This 15-pin port is for a VGA monitor or other VGA-compatible devices.20LAN (RJ-45) connector20This port connects a microphone.201.6.2 CF Power Connector (CFPJ1)211.6.3 ATX Power Connector (CN5)211.6.4 Power Fan Connector (CN7)211.6.5 SM Bus Connector (CN8)221.6.6 Serial port 1 in RS-232 mode (COMB1)221.6.7 Serial port 2 in RS-232 mode (COMB2)221.6.8 Front Panel Connector (FPANEL1)231.6.9 IrDA Connector (IRB1)241.6.10 Primary IDE Connector (IDEB1)241.6.11 AC97 Line-in Connector (J1)251.6.12 GPIO Connector (J2)251.6.13 LCD Inverter Connector (LCDB1)261.6.14 LVDS Connector (LVDS1)261.6.15 TTL Connector (TTL1)271.6.16 USB 2.0 Connector (USBB1)27Taille: 690 koPages: 27Language: EnglishOuvrir le manuel