Fiche De Données (DAV-7717)Table des matièresMounting Pole Kit1Installation Manual1Components1Tools and Materials Needed1• Adjustable wrench1• Drill with 1/4" (6 mm) bit1Secure the ISS to the Support Tube1Note: Remember, when mounting both sides together, that whichever side of the ISS is mounted first, the U-bolt from the opposite side ALSO must be placed around the pole before you tighten anything. (If it is not, there is no way to slide it in later.)2Mount the Extension Tube21. In a fence-post or other flat vertical surface, drill two holes, using one of the 1-1/8" saddles as a guide.22. Drill another set of holes at least 12" (0.3 m) away from the first holes.23. Using the 5/16" flat washers and lag screws, secure the saddles against the extension tube and into the post.24. Tighten the lag screws until the tube will not slide up or down no matter how hard you try to move it.3Install the Support Tube on the Extension Tube31. Insert the swaged end of the support tube in the open top of the extension tube.32. Place the U-bolt provided in the mounting pole kit around the tubes where they overlap. Secure with flat washers, lock washers, and hex nuts as shown in the illustration.33. Tighten the hex nuts quite firmly, until the U-bolt begins to dent the tubing slightly. We recommend the use of a torque wrench with 25 lb-ft of pressure to fasten the hex nuts.3Note: Do not use over 25 lb-ft torque wrench, it may damage the U-bolts.44. Use the 8" cable ties to secure cable as needed.4Taille: 470 koPages: 4Language: EnglishOuvrir le manuel
