Manuel D’UtilisationTable des matièrest6y1English1Installation Instructions1Specifications1Two-Way Wireless Siren Enrollment11. Enter the enrollment mode through installer programming, see section [898] in the alarm system installation manual.12. Power up the indoor siren, if it is not already powered up.13. Tamper the indoor siren using the tamper switch.14. The indoor siren sends a request to the security panel to enroll on the system.15. The Keypad displays the electronic serial number which must be confirmed by keying in [*]. If the electronic serial number is incorrect, press [#] and repeat this step.16. Select the module number that the device should be enrolled as.17. Repeat starting from step 2. to enroll each additional indoor siren.11. Enter the enrollment mode through installer programming, see section [804] in the alarm system installation manual.12. Select the module number that the device will be enrolled as. See sections [301]- [304] for sirens.13. Enter the serial number using either the Keypad, or DLS.1Placement Test11. Place the security panel into placement test, see section [906].12. Start the test by tampering and restoring the siren being tested, or pressing and holding the Test button for 2 seconds (the siren will give a beep).13. The siren will respond with one beep if the location is “Good” or three beeps if the siren is at a “Bad” location.1Physical Installation11. Open the WT4901 by inserting a screwdriver into the slots and gently pry on the front cover until it separates from the backplate.12. If the batteries are not installed, install the batteries as shown in the sequence indicated by the engraving.13. Position the backplate on a flat mounting surface and mark this location.14. Secure the backplate to the mounting surface with all the screws provided.15. Hinge the front cover to the backplate carefully, to correctly align it with the tamper switch, then snap it onto the backplate. The wall tamper switch must remain closed when the indoor siren is mounted.1Test Button1Battery Replacement1Taille: 230 koPages: 2Language: EnglishOuvrir le manuel