Manuels d'utilisation pour Ericsson LBI-39076B

Table des matières

• REGULATORY COMPLIANCE

  7
• SPECIFICATIONS

  9
• INTRODUCTION

  10
• DESCRIPTION

  10
• OVERVIEW

  10
• GTI UNITS

  11
• GTI INTERFACE BOARD

  12
• GTI CONFIGURATOR SOFTWARE

  12
• IAM

  12
• INSTALLATION

  12
• OVERVIEW

  12
• 1. RADIO SOFTWARE

  14
• 2. SITE CONTROLLER HARDWARE

  14
• 3. SITE CONTROLLER SOFTWARE

  14
• Application Software PROMs

  15
• Personality PROMs

  15
• 4. RADIO CHANNEL ASSIGNMENTS

  15
• 5. GTI SOFTWARE

  16
• Main Board

  16
• Processor Board

  17
• Interface Board

  17
• 6. GTI TELEPHONE INTERFACE

  18
• Revision-A Main Board

  18
• Revision-D or E Main Board

  22
• 7. GTI DIP SWITCH SETTINGS

  22
• 8. GTI INTERFACE BOARD MOUNTING

  23
• 9. GTI & IAM MOUNTING

  24
• 10. GTI CONNECTIONS

  24
• Telephone Line

  24
• MASTR III Power Supply/Audio

  25
• MASTR II or IIe Power Supply/Audio

  25
• PCM/Data Bus

  25
• Site Controller Computer

  26
• 11. IAM SOFTWARE

  26
• 12. IAM CONNECTIONS

  27
• Power Supply

  27
• PCM/Data Bus

  27
• Alarm Outputs

  27
• Printer RS-232 Port

  27
• 13. IAM DIP SWITCH SETTINGS

  28
• 14. GETC MODIFICATION

  28
• CONFIGURATION

  29
• OVERVIEW

  29
• SITE CONTROLLER DATABASE

  29
• Operation without System Manager

  29
• Interconnect Timing Parameters

  29
• Operation with System Manager

  30
• GTI DATABASE

  33
• Local Data Link

  33
• Remote Data Link

  34
• OPERATION

  35
• GTI UNITS

  35
• Indicators

  35
• Resets

  35
• Alarms

  35
• IAM

  35
• Indicators

  35
• Front Panel Connector

  36
• Printer

  36
• Resets

  36
• Backup

  37
• Status

  37
• Alarms

  37
• INTERCONNECT CALLS

  37
• Overview

  37
• Telephone-Originated Call

  38
• Radio-Originated Call

  40
• MAINTENANCE

  43
• GTI REMOVAL

  43
• MASTR II or IIe Repeaters

  43
• MASTR III Repeaters

  43
• ELI SOFTWARE UPGRADES

  44
• Plan A - All at One Time

  45
• Plan B - Half at a Time

  46
• Plan C - One at a Time

  48
• IAM Unit

  50
• TROUBLESHOOTING

  51
• GLOSSARY

  55
• PARTS LIST

  57
• INTERCONNECTION DIAGRAM

  58
• SCHEMATIC DIAGRAM

  59
• INSTALLATION CHECKLIST

  60
• Figure 1 - Location of ELI Components in a Typical EDACS Installation

  10
• Figure 2 - GTI Audio Paths

  11
• Figure 3 - Card Layout for PDP Upgraded to VAX

  14
• Figure 4 - Location of Fastener Screws on Computer

  14
• Figure 5 - Location of PROM Card in Computer

  14
• Figure 6 - Location of PROM Card in Older Computer

  14
• Figure 7 - Location of PROMs on PROM Card

  15
• Figure 8 - Application Software PROM Label

  15
• Figure 9 - Personality PROM Label

  15
• Figure 10 - GTI Software Locations

  16
• Figure 11 - GTI 552 Software (Rev A Main Board)

  16
• Figure 12 - GTI DSP Software (Rev A Main Board)

  16
• Figure 13 - GTI 552 Software (Rev D or E Main Boards)

  17
• Figure 14 - GTI DSP Software (Rev D or E Main Board)

  17
• Figure 15 - GTI Main Software Label

  17
• Figure 16 - GTI Interface Board Software Locations

  17
• Figure 17 - GTI Master Software Label

  17
• Figure 18 - Jumper Locations (Rev A Main Board)

  18
• Figure 19 - End-to-End Loop Start (Rev A Main Board)

  19
• Figure 20 - 4-Wire E&M Microwave (Rev A Main Board)

  19
• Figure 21 - End-to-End Ground Start (Rev A Main Board)

  19
• Figure 22 - 4-Wire E&M Type 1 (Rev A Main Board)

  19
• Figure 23 - Telephone Interface Circuit (Rev A Main Board)

  21
• Figure 24 - Jumper Locations (Rev D or E Main Board)

  22
• Figure 25 - 4-Wire E&M Card (Rev D or E Main Board)

  22
• Figure 26 - GTI Unit DIP Switch Orientation

  22
• Figure 27 - GTI Circuit Board Layout

  23
• Figure 28 - Connections to GTI

  24
• Figure 29 - Connections to ELI TELCO Interface Module

  24
• Figure 30 - MASTR III Connections

  25
• Figure 31 - MASTR II & IIe Connections

  25
• Figure 32 - PCM / Data Bus Cable

  26
• Figure 33 - Site Controller Computer Connections

  26
• Figure 34 - IAM Software Locations

  26
• Figure 35 - IAM Software Label

  27
• Figure 36 - IAM Rear Panel Connections

  27
• Figure 37 - IAM Power Supply Connections

  27
• Figure 38 - IAM Alarm Outputs

  27
• Figure 39 - IAM Printer RS-232 Port

  28
• Figure 40 - IAM DIP Switch Settings

  28
• Figure 41 - Local GTI Connection for 9-Pin COM Port

  34
• Figure 42 - Local GTI Connection for 25-Pin COM Port

  34
• Figure 43 - Front Panel of GTI Unit

  35
• Figure 44 - Front Panel of IAM

  35
• Figure 45 - Position of Temporary Jumper

  43
• Table 1 - Sequence of Installation Activities (with Step # References)

  13
• Table 2 - Configurations by Line Type (Rev A Main Board)

  18
• Table 3 - Configurations by Interface Characteristic (Rev A Main Board)

  19
• Table 4 - Configurations (Rev D or E Main Board)

  22
• Table 5 - Defined DIP Switch Settings for GTI Units

  23
• Table 6 - Local Interconnect Timing Parameter Adjustments For Release 7

  30
• Table 7 - Software Compatibility by Release Number

  44
• Table 8 - Software Compatibility by Main Board Revision Number

  45
• Table 9 - Troubleshooting Symptoms

  51