Manuel D’UtilisationTable des matièresBEFORE YOU BEGIN...................................................................................…. 12IMPORTANT SAFETY NOTICES..................................................................…. 22HARDWARE IDENTIFIER.....…....................................................................…. 42ASSEMBLY INSTRUCTIONS........................................................................…. 52EXPLODED DIAGRAM……………………………………………………………… 92PARTS LIST...............................................................................................……. 102WARRANTY.................................................................................................….. 112ORDERING PARTS.......................................................................................… 112ASSEMBLY INSTRUCTION6Insert the two Upper Backrest Supports (#8) into two Lower Backrest Supports (#9). Secure them with two M6 x 1 3/8” Hex Bolts (#20), four Ø ½” Washers (#25), and two M6 Aircraft Nuts (#28).8Attach the side-holes on the Lower Backrest Supports (#9) to each end of the pivot on the Seat Support Frame (#6). Align the holes and insert a M10 x 6 7/8” Axle (#17) through the holes. Secure it with two Ø ¾” Washers (#23) and M10 Aircraft Nuts (#27).8Place the Lower Backrest Board (#10) onto the Backrest Supports. Secure it with four M6 x 1 3/8” Hex Bolts (#20) and Ø ½” Washers (#25).8Place the Upper Backrest Board (#11) onto the Backrest Supports. Secure it with two M6 x 1 3/8” Hex Bolts (#20) and Ø ½” Washers (#25).8Attach the Leg Developer (#29) to the Leg Developer Holder (#7). Secure it with one M10 x 2 1/8” Hex Bolt (#19), two Ø ¾” Washers (#23), and one M10 Aircraft Nut (#27). Do not over tighten the Nut and Bolt. Make sure the Leg Developer is able to swivel.9Insert the Weight Post (#31) into the Leg Developer. Secure it with one M8 x 1 ¾” Hex Bolt (#22), two Ø 5/8” Washers (#24), and one M8 Aircraft Nut (#26).9Insert the Foam Tube (#30) halfway through the holes on the Leg Developer. Attach two Foam Rolls (#32) onto the Tube from both ends.9DIAGRAM 4920 M6 x 1 3/8” Hex Bolt 811Taille: 970 koPages: 12Language: EnglishOuvrir le manuel