Manuel D’UtilisationTable des matièresBEFORE YOU BEGIN...................................................................................…. 12IMPORTANT SAFETY NOTICES..................................................................…. 22HARDWARE PACK……….....…....................................................................…. 32ASSEMBLY INSTRUCTIONS........................................................................…. 42EXPLODED DIAGRAM………………………………………………………………. 102PARTS LIST...............................................................................................……. 112WARRANTY.................................…..............................................................…. 122ORDERING PARTS.......................…..............................................................… 122ASSEMBLY INSTRUCTION5Attach the Leg Developer (#6) to the Front Support (#5). Secure it with one M10 x 2 3/8” Hex Bolt (#21), two Ø ¾” Washers (#31), and one M10 Aircraft Nut (#27). Do not over tighten the Bolt. Make sure the Leg Developer is able to swivel.7Insert two Foam Tubes (#13) halfway through the holes on the Leg Developer. Push four Foam Rolls (#12) onto the Tubes from both sides.7Place a Spring Clip (#39) onto the weight post on the Leg Developer.7Attach the hole-side of the Backrest Supports (#7) onto both ends of the pivot on the Main Seat Support (#3). Place the other end rest against the Backrest Adjustment Bar (#11).8Place the Backrest Board (#8) onto the Backrest Supports. Secure it with four M6 x 1 5/8” Hex Bolts (#23) and Ø ½” Washers (#25).8Place the Seat Pad (#9) onto the Main Seat Support. Secure it with four M6 x 5/8” Hex Bolts (#22) and Ø ½” Washers (#25).8DIAGRAM 48Attach the Arm Curl Pad (#34) to the Arm Curl Stand (#42). Secure it with two M8 x ¾” Hex Bolts (#33) and Ø 5/8” Washers (#26).9Insert the Arm Curl Stand into the top opening on the Front Support and secure it with a Lock Knob (#32).9DIAGRAM 5920 M8 x 2 ½”Hex Bolt 412Taille: 860 koPages: 13Language: EnglishOuvrir le manuel
