Manuel D’UtilisationTable des matièresBEFORE YOU BEGIN...................................................................................…. 12IMPORTANT SAFETY NOTICES..................................................................…. 22HARDWARE IDENTIFIER.....…....................................................................…. 42ASSEMBLY INSTRUCTIONS........................................................................…. 52EXPLODED DIAGRAM………………………………………………………………. 102PARTS LIST...............................................................................................……. 112WARRANTY.................................................................................................…. 122ORDERING PARTS.......................................................................................… 122ASSEMBLY INSTRUCTION6Attach the Leg Developer (#10) to the Front Leg (#8). Secure it with one M8 x 3 1/8” Allen Bolt (#28), two Ø 5/8” Washers (#33), and one M8 Aircraft Nut (#36).8Insert two Foam Tubes (#11) halfway through the holes on the Leg Developer. Push four Foam Rolls (#19) onto the Tubes from both sides.8Place a Spring Clip (#22) onto the weight post on the Leg Developer.8Attach the hole-side of the Backrest Supports (#13) onto both ends of the pivot on the Main Seat Support (#6). Place the other end rest against the Backrest Adjustment Bar (#4).9Place the Backrest Board (#14) onto the Backrest Supports. Secure it with four M6 x 1 3/8” Philips Screws (#31) and Ø ½” Washers (#34).9Place the Seat Pad (#15) onto the Main Seat Support. Secure it with four M6 x 1 3/8” Philips Screws (#31) and Ø ½” Washers (#34).9DIAGRAM 49Attach the Arm Curl Pad (#16) to the Arm Curl Stand (#12). Secure it with two M8 x 5/8” Allen Bolts (#30) and Ø 5/8” Washers (#33).10Insert the Arm Curl Stand into the top opening on the Front Leg. Secure it with a Lock Knob (#24).10DIAGRAM 51020 2” Round End Cap 212Taille: 1,2 MoPages: 13Language: EnglishOuvrir le manuel