Sony HXCU-D70 Manuale Utente

2

The model and serial numbers are located at the rear.
Record these numbers in the spaces provided below. Refer to 
them whenever you call upon your Sony dealer regarding this 
product.

Model No.                               Serial No.                                

WARNING: THIS WARNING IS APPLICABLE FOR USA 
ONLY.

If used in USA, use the UL LISTED power cord specified 
below.
DO NOT USE ANY OTHER POWER CORD.

Plug Cap Parallel blade with ground pin (NEMA 5-15P 

Configuration)

Cord

Type SJT, three 16 or 18 AWG wires

Length

Minimum 1.5 m (4 ft. 11in.), Less than 2.5 m 
(8 ft. 3 in.)

Rating

Minimum 10A, 125V

Using this unit at a voltage other than 120V may require the 
use of a different line cord or attachment plug, or both. To 
reduce the risk of fire or electric shock, refer servicing to 
qualified service personnel.

WARNING: THIS WARNING IS APPLICABLE FOR OTHER 
COUNTRIES.

1. Use the approved Power Cord (3-core mains lead)/

Appliance Connector/Plug with earthing-contacts that 
conforms to the safety regulations of each country if 
applicable.

2. Use the Power Cord (3-core mains lead)/Appliance 

Connector/Plug conforming to the proper ratings (Voltage, 
Ampere).

If you have questions on the use of the above Power Cord/
Appliance Connector/Plug, please consult a qualified service 
personnel.

Dette utstyret kan kobles til et IT-strømfordelingssystem.

This equipment has been tested and found to comply with the 
limits for a Class A digital device, pursuant to Part 15 of the 
FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference when the equipment is 
operated in a commercial environment. This equipment 
generates, uses, and can radiate radio frequency energy and, 
if not installed and used in accordance with the instruction 
manual, may cause harmful interference to radio 
communications. Operation of this equipment in a residential 
area is likely to cause harmful interference in which case the 
user will be required to correct the interference at his own 
expense.

You are cautioned that any changes or modifications not 
expressly approved in this manual could void your authority to 
operate this equipment.

All interface cables used to connect peripherals must be 
shielded in order to comply with the limits for a digital device 
pursuant to Subpart B of Part 15 of FCC Rules.

This device complies with Part 15 of the FCC Rules. Operation 
is subject to the following two conditions: (1) this device may 
not cause harmful interference, and (2) this device must 
accept any interference received, including interference that 
may cause undesired operation.

For the customers in Canada
This Class A digital apparatus complies with Canadian ICES-
003.

This product with the CE marking complies with the EMC 
Directive issued by the Commission of the European 
Community. 
Compliance with this directive implies conformity to the 
following European standards:
• EN55103-1: Electromagnetic Interference(Emission)
• EN55103-2: Electromagnetic Susceptibility(Immunity)
This product is intended for use in the following 
Electromagnetic Environment: E4 (controlled EMC 
environment, ex. TV studio).

This is a Class A product. In a domestic environment, this 
product may cause radio interference in which case the user 
may be required to take adequate measures.

This symbol is intended to alert the user to 
the presence of important operating and 
maintenance (servicing) instructions in the 
literature accompanying the appliance.