Accusplit 1620 Dépliant

While gently holding the belt clip open, slide the pedometer 

onto your belt or the top edge of your pants or skirt. It should 

fit snugly and level, above one knee. 

Note: The pedometer should be as vertical as possible. Walkers 

with larger stomachs may find it helpful to wear the pedometer 

farther back on the body, toward one hip. 

The cover must be closed for the pedometer to work. To avoid 

losing or dropping your pedometer, use the included leash and 

clip to fasten the pedometer securely to your clothing. 

Attaching the Leash: Attach the pedometer to the leash by 

looping the leash around the pedometer belt clip. Next, clasp the 

waistband of your clothing with the attached metal clip. You can 

also use a safety pin to fasten the leash to your clothing, loop 

the leash through your belt or belt loop, or use a badge holder. 

Once you put on your pedometer with the cover closed, it will 

automatically begin to record your steps. 

ACCUSPLIT, Inc.  •  6120 Stoneridge Mall Rd., Suite 210  •  Pleasanton, CA 94588 USA

800-965-2008  •  925-226-0888  •  FAX 925-463-0147  •  www.ACCUSPLIT.com  •  support@ACCUSPLIT.com

ACCUSPLIT®
       EAGLE

™

 

Congratulations on taking the first step to wellness with your purchase 

of an ACCUSPLIT pedometer. It’s easy to set up your new pedometer. 

Just follow the steps below, and start walking!

970-066

(Badge holder not included)

See label inside the lid of the pedometer.

•   STePS: Counts steps taken since last ReSeT.  

  Reset daily to count each day’s steps.

1.  To filter out random movements, the unit remains in standby mode until  

  5 continuous steps are registered. Only then are the 5 steps calculated in,  

  and an Active indicator “▲” appears on the upper left of display.
2.  When regular walk/run movement stops, after 2 seconds the timer pauses  

  and the unit switches to standby status (Active indicator “▲” disappears)

Most people prefer to reset step counts daily. To reset: Press and hold yellow 

ReSeT button for at least two seconds to reset to zero. 

When the display starts to dim or goes blank, it is time to replace the battery. 

Your pedometer uses one Type LR43 (L1142) 1.5 volt alkaline battery. To 

replace:
1.  Insert a coin into the slot on the bottom of the case, and twist counter- 

  clockwise to loosen the case front. Lift case front away.
2.  Using a pen or other thin object, push battery sideways out of its holder.  

  Replace it with a new battery. The battery’s positive (+) terminal should  

  be FACe UP while you put it into the pedometer.
3.  Align case front over the pedometer and press gently to  

  snap cover back into place, starting with top.

ACCUSPLIT 

EAGLE 

™

425 I 

Yellow:

ReSeT

REGISTER NOW 

Please return 

your AE1620 Registration to the 
Repair Center address in the 
warranty, and we will let you 
know about future products. 

Email (preferred)
User