Dimension One Spas 2003 Manuale Utente

2003 Owner’s Manual 

All systems are equipped with a 12-volt light using a GE912 bulb. To change the bulb:  
 

1.  Turn the power off and drain the system below the level of the 

light.  

2.  Using the special tool provided in the owner’s manual 

packet, unscrew the cover for the light housing.  

3.  Remove the old bulb and install the new bulb.  
4.  Use the special tool to replace the cover for the light 

housing.  

5.  Check to ensure proper operation of the new bulb before 

refilling the system. 

 

 

 
Do not attempt to remove the light housing cover without lowering the water level 
below the light housing cover. 

 

 

 

 
Do not attempt to remove the light housing cover without the special tool. If you are not 
able to locate it, contact the Dimension One Spas’ Service Department to have one sent. 

 

 

 

 
Be sure the O-ring is not damaged and is properly in place when replacing the lens. 
Contact Dimension One Spas if a replacement O-ring is needed. 

 

 

 

 

A Dynamic L.E.D. Light is available as an optional accessory for many models. This 
light is preprogrammed with 13 different light shows. This light is also replaced in the 
same manner as described in the previous paragraph. Contact your dealer or visit our 
Virtual Showroom at 

 to see if it is available for your model. 

 

26