Pioneer V5000 Manuale Utente
DVD-V5000 DVD Player
RS-232 Command Protocol
9-pin D-Sub connector
Pin #
Terminal
Input/Output
Function
1 NC
2 TxD Output
send
data
3 RxD Input
receive
data
4 DTR Output
enable
data
receiving
5 GND
--
ground
6
DSR
Input
data set ready
7
RTS
Output
request to send
8
CTS
Input
clear to send
9 NC
2.3
Computer Control Functions
2.3.1 Serial Control (see Chapters 3, 4, 5 and 6)
The player and computer are based upon the RS-232C protocol and are
connected through the TxD, RxD, DTR and GND terminals.
connected through the TxD, RxD, DTR and GND terminals.
2.3.2 Extend Terminal Control (see Chapter 9)
Control the player with the Extend Terminal Switches (SW#).
Even if the Key Lock is set (active), the extend terminal control is
available.
available.
2.3.3 External Power Control
Control the player’s power with the Power Pin within the Interface
Connector.
Connector.
If the player detects a high signal throughput (100m/sec or more) during
the Standby mode, the player powers ON. If the player detects the same
signal during the Power ON mode, the player powers OFF and switches
to the Standby mode.
the Standby mode, the player powers ON. If the player detects the same
signal during the Power ON mode, the player powers OFF and switches
to the Standby mode.
The specifications for the Power pin are as follows:
Maximum Input Voltage
Less Than 12V
High Level Signal
More Than 4.5V
Low Level Signal
Less Than 0.5V
Standby mode
more
than
100 msec
Power ON
- 3