Polycom The Remote Control Manuale Utente
PolyCom EX User Manual
Aug. 18, 2004 v 1.1
Page 3 of 13
C
HAPTER
1 – G
ENERAL
S
YSTEM
I
NFORMATION
USING THE REMOTE CONTROL
The remote control works very much like a television remote control. The remote control is
used to move the camera right and left (pan), up and down (tilt), zoom in and out, adjust the
volume and make video calls.
There are two sensors located on the bottom of the remote control. When you place the
remote control down on the table, the image that you see on your monitor may change. To
keep the image the same, lay the remote control on its side when not in use.
The word Far refers to the site(s) that you are connecting to over the PolyCom EX. This is
commonly called the “Remote Site.”
The word Near refers to the site at which you’re located. This is commonly called the “Local
Site.”
used to move the camera right and left (pan), up and down (tilt), zoom in and out, adjust the
volume and make video calls.
There are two sensors located on the bottom of the remote control. When you place the
remote control down on the table, the image that you see on your monitor may change. To
keep the image the same, lay the remote control on its side when not in use.
The word Far refers to the site(s) that you are connecting to over the PolyCom EX. This is
commonly called the “Remote Site.”
The word Near refers to the site at which you’re located. This is commonly called the “Local
Site.”
Copyright © NORTH Network 1998.
The information herein may be reproduced provided that it is accurate and NORTH Network is credited as the source.