Yamaha HTR-5760 Manuale Utente
65
English
EDITING SOUND FIELD PARAMETERS
ADDITIONAL
INFO
RMA
T
IO
N
N
4
Press
u
/
d
to select
the parameters.
5
Press
j
/
i
to change
the parameter value.
When you set a parameter
to a value other than the
factory-set value, an
asterisk mark (*) appears
by the parameter name on
the front panel display.
to a value other than the
factory-set value, an
asterisk mark (*) appears
by the parameter name on
the front panel display.
6
Repeat steps 3 through 5 as necessary to
change other program parameters.
change other program parameters.
You cannot change parameter values when “MEMORY GUARD”
is set to ON. If you want to change the parameter values, set
“MEMORY GUARD” to OFF (see page 59).
is set to ON. If you want to change the parameter values, set
“MEMORY GUARD” to OFF (see page 59).
■
Resetting parameters to the factory
presets
presets
To reset a certain parameter
Select the parameter you want to reset, then press j / i
repeatedly until the asterisk mark (*) next to the parameter
name disappears.
repeatedly until the asterisk mark (*) next to the parameter
name disappears.
To reset all parameters
Use PARAM. INI (see page 59).
Note
Memory back-up
The memory back-up circuit prevents the stored data
from being lost even if this unit is set in the standby
mode, the power cord is disconnected from the AC
outlet, or the power supply is temporarily cut due to
power failure. However, if the power is cut for more
than one week, the parameter values will return to the
factory settings. If this happens, edit the parameter
value again.
from being lost even if this unit is set in the standby
mode, the power cord is disconnected from the AC
outlet, or the power supply is temporarily cut due to
power failure. However, if the power is cut for more
than one week, the parameter values will return to the
factory settings. If this happens, edit the parameter
value again.
SELECT
PRESET/CH
SELECT
PRESET/CH
00_HTR-5760_U_EN.book Page 65 Tuesday, February 17, 2004 10:47 AM