Planar touch screen lcd monitors Manuale Utente

11 

To setup this display, please refer to the following figure and procedures. 

1.  Be sure all equipment is turned off. 

2.  Connect the AC power cord to the power connector on the monitor and 

the other end into an electrical outlet (12.1). 

3.  Connect the D-SUB cable from the display’s VGA input connector to the 

D-SUB connector of your host computer and tighten the screws (12.1). 

4.  Connect the Audio-In cable from the audio input port of your display to 

the Audio-out port of your computer (12.1). 

5.  Connect the RS-232 or USB cable from the RS-232 or USB port of your 

display to the RS-232 port or USB port (12.1) of your computer. 

6.  Configure the touch screen. Refer to the “Touch Screen Driver 

Installation” section on page 25 . 

7.  Once the touch screen is configured, the monitor is ready for use. 

To ensure the LCD display works well with your computer, please 
configure the display mode of your graphics card to make it less than or 
equal to 1280 x 1024 resolution and make sure the timing of the display 
mode is compatible with the LCD display. 
We have listed the compatible “Video Modes” of your LCD   
display in the appendix for your reference.