JVC HR-S9400U Manuale Utente

The VCR's remote control can control functions on the brands
of DBS (Direct Broadcast Satellite) receivers listed below.

1

2

4

5

3

6

8

0

7

9

TURN ON THE DBS

RECEIVER

Turn the power on using the DBS receiver’s remote
control.

SET REMOTE CONTROL

MODE

Set the TV/CABLE/DBS/VCR switch on the VCR’s
remote control to CABLE/DBS.

ENTER DBS RECEIVER BRAND

While holding down POWER on the VCR's remote
control, use the NUMBER keys to enter the DBS receiver
brand number from the chart below and then press STOP.
Follow the example shown at bottom left.

● Once you have set the remote control to operate the

DBS receiver, you don't have to repeat this step until
you replace the remote control's batteries.

OPERATE DBS RECEIVER

First, press POWER to see if the DBS receiver’s power
goes off as it should. If it does, try other functions
(CH

5∞ and the NUMBER keys can be used to operate

the DBS receiver).

● For some brands of DBS receiver, you must press

ENTER after having pressed the NUMBER keys.

● To return the remote to VCR control, set the TV/

CABLE/DBS/VCR switch to VCR.

● You must set the DBS receiver brand for your remote control

and the DBS receiver brand for your Controller (

Z

 pg. 25)

separately.

● It is possible that the remote control will not operate your DBS

receiver even if the DBS receiver’s channels automatically
change during timer recording using the Controller.

● Though ECHOSTAR has a number of different remote codes,

this remote control is applicable only to one of those codes
preset at the factory.

● It's not possible to set the remote control for both your cable

box and your DBS receiver at the same time; you can only set
the remote control to the brand  of either one.

(Ex.)  To set remote control to RCA 80:

STOP

POWER

8

0

Release

Hold
down

Press in succession

RCA (DSS)

80

SONY (DSS)

81

PRIMESTAR

90

ECHOSTAR

91