A&D EJ-6100 Manuale Utente

 22

 

The following options are available for the EJ series: 

 

‰

 EJ-02  USB 

interface 

‰

  EJ-03 

RS-232C serial interface 

‰

  EJ-07 

Underhook for EJ-3000 / EJ-4100 / EJ-6100 

‰

  EJ-08 

Underhook for EJ-1500 / EJ-2000 

‰

 EJ-11  Breeze 

break 

‰

 EJ-12  Carrying 

case 

‰

  EJ-13 

Density Determination Kit for EJ-120 / EJ-200 / EJ-300 / EJ-410 / EJ-610 

 
 

‰

‰

  The EJ-02 is installed to the same slot as EJ-03 and see “9-2. EJ-03 RS-232C 

serial interface”. 

‰

  The EJ-02 will be used to transmit the weight data (numerical value only) 

uni-directionally to a personal computer via USB. 

‰

  The EJ-02 can transmit the weight data (numerical value only) directly to other 

application software such as Microsoft Excel, Word, memo pad, and so on. 

‰

  The driver is not necessary to install. 

‰

  The EJ-02 cannot be used for bidirectional communication. 

 
 

This interface allows the EJ series to be connected with a multifunction printer or a 
personal computer. 

‰

  EJ-03 cannot be used together with EJ-02. 

‰

  The RS-232C interface has the following four modes. 

Stream mode 

Outputs data continuously. 

Key mode 

Outputs data by pressing the    PRINT    key. 

Auto-print mode 

Outputs data which meets the conditions of auto-print. 

Command mode 

Controls the balance using commands from a computer. 

‰

  Set the parameters of the data format (bps and btpr) and data output mode 

(prt), as necessary. 

‰

  Use a D-sub 9 pin cable (straight type) to connect with a computer. 

Optional cable: AX-KO2466-200    D-Sub 9 pin / 9 pin cable with 2 m long. 

 

EJ-03 Installation 

1. Turn off the balance and disconnect the AC 

adapter if used. 

2. Remove the cover of the option slot on the 

rear by pressing and lowering it down. 

3. Connect the connector in the slot to the 

EJ-03 unit and insert it into the slot. 

Press and lower
down the cover. 

Option slot for 
EJ-02 / EJ-03