Grizzly G0756 Manuale Utente

-18-

Model G0756 (Mfg. Since 2/13)

Test Run

once the preceding setup procedures are com-
plete, test run your machine to make sure it runs
properly and is ready for regular operation.

the  test  run  consists  of  verifying  the  following:
1)  the  motor  powers  up  and  runs  correctly,  2)
the  eMergenCy  stop  button  and  chip  guard
safety  features  work  correctly,  and  3)  the  motor
rotates  in  the  correct  direction  (machine  is  not
wired out of phase).

before starting the drill press, make sure

you have performed the preceding setup

instructions, and you have read through the

rest of the manual and are familiar with the

various functions and safety features on

this machine. failure to follow this warning

could result in serious personal injury or

even death!

To test run the machine:

1. Make sure all tools and objects used during

setup are cleared away from the machine.

2. Make sure the machine is properly lubricated.

3. turn the Master power switch (figure 11)

ON.

5. Make sure the power cord and wires have

slack between the strain relief and terminal
connections so that they do not bind, then
tighten the strain relief to secure the cord.

Note:

The strain relief must be tightened

against the outer jacket of the cord. Avoid
over-tightening the strain relief or it may
crush the cord and cause a short.

6. test the strain relief to ensure it is properly

tightened by pulling the cord from outside the
box with light-to-moderate force. When the
strain relief is properly tightened, the cord will
not move inside the cabinet.

7. install a neMA 15-15 plug on the other end

of the power cord per the plug manufacturer's
instructions.

8. Close and secure the main electrical box

door.

9. plug the power cord into a power source with

a matching receptacle, as specified in

circuit

Requirements for 220v on Page 10.

Note: If you discover during the Test Run that
the drill press will not operate, or that the spindle
runs backwards, the drill press may be wired out
of phase.

Correcting the phase polarity requires reversing
the positions where the L1 and L3 wires are con-
nected. Due to the high voltage and risk of serious
shock involved, we strongly recommend this pro-
cedure only be done by an electrician or qualified
service personnel.

figure 11. Master power switch.

Master power switch

if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review

Troubleshooting on Page 35.

if you still cannot remedy a problem, contact our
tech support at (570) 546-9663 for assistance.