Motorola G24 Manuale Utente
Chapter 3: AT Commands Reference
December 31, 2007
AT Commands Reference Manual
3-135
If after aborting AT+CMGS command execution and before result of operation was
reported by G24, a second AT+CMGS command is executed, then the result of the second
AT+CMGS operation only will be reported by G24.
reported by G24, a second AT+CMGS command is executed, then the result of the second
AT+CMGS operation only will be reported by G24.
+CSCB, Cell Broadcast Messages
This command handles the selection of cell broadcast message types and data coding schemes
received by the G24.
received by the G24.
Note:
The Channel and DCS
list is saved to the SIM card.
The maximum number of active channels is SIM dependent.
The AT+CSCB set command is not available when the phone is either in "Emergency
Only" or "No Service" status.
Only" or "No Service" status.
Command Type
Syntax
Response/Action
Remarks
Set
+CSCB=[<mode>
[,<mids>[,<dcss>]
]]
]]
If mode=0 and <mids>
is not specified, then
no channels are
accepted, and the g24
channel/mid list is
cleared.
is not specified, then
no channels are
accepted, and the g24
channel/mid list is
cleared.
If mode=1 and <mids>
is not
specified, then
the G24 channel list will
stay as is.
is not
specified, then
the G24 channel list will
stay as is.
OK
or:
+CME ERROE:<err>
The Set command sets the cell
broadcast message type and data
coding scheme.
broadcast message type and data
coding scheme.
Read
+CSCB?
+CSCB:
<mode>,<mids>,<dcss>
The Read command displays the
current MID and DCS settings.
current MID and DCS settings.
Test
+CSCB=?
+CSCB: (list of
supported <mode>s)
The Test command displays the
supported values of <mode>.
supported values of <mode>.