Motorola G24 Manuale Utente

Audio Control of Path, Gain and Algorithms is available by these two different modes' sets of 
commands. It is advised to select the audio mode according to the application needs, either the 
'Basic Audio' set or the 'Advanced Audio'.

This mode’s set of commands suits most users. It provides a simple audio control. In this mode 
the G24 will also adjust the paths automatically upon headset interrupt. The G24 powers up in 
'Basic Audio' mode.

Basic audio specific commands are: +CRSL, +CLVL, +CMUT, S94, S96.

 shows the basic audio setup.

This mode suits users which require a full control of the audio. When using these advanced 
commands the audio control will ignore the headset interrupt (when the headset will be connected 
the paths will not change automatically). Upon invoking any of the advanced Audio specific 
commands: +MAVOL, +MAPATH, +MAFEAT, +MAMUT the G24 will enter 'Advanced Audio' 
mode. G24 will remain in 'Advanced audio' mode until power cycle.

While in Advanced Mode, all Basic Audio AT commands (+CRSL, +CLVL, +CMUT, S94, S96) 
are blocked and will return an error.

 shows the advanced setup.

HeadSet m ode

The user has attached a device to the HDST _INT line  

,

 

and caused a change in the audio input and output path .

Idle mode

There is no signal on the HDST _INT line.

Mic

Speaker

H eadset
Speaker

H eadset

Mic

Mic

Speaker

H eadset
Speaker

H eadset

Mic

The m ic

and speaker active are

set using A T+M A PA TH

.

.

Mic

Speaker

H eadset
Speaker

H eadset

Mic