Panasonic MN101C77C Manuale Utente
![Panasonic](https://files.manualsbrain.com/attachments/8f677e63fb64cbb6c62d09e6242996e7631380a8/common/fit/150/50/34d700d3fb727c767799b2da5cc474b219c0a4312e9e3044c99491a2fb9a/brand_logo.png)
IV - 17
Chapter 4 I/O Ports
Port 2
4-4
Port 2
4-4-1
Description
General Port Setup
Each bit of the port 2 control I/O direction register (P2DIR) can be set individually to set pins as input or
output. The control flag of the port 2 direction control register (P2DIR) should be set to "1" for output
mode, and "0" for input mode.
To read input data of pin, set the control flag of the port 2 direction control register (P2DIR) to "0" and
read the value of the port 2 input register (P2IN).
To output data to pin, set the control flag of the port 2 direction control register (P2DIR) to "1" and write
the value of the port 2 output register (P2OUT).
P27 is reset pin. When the software is reset, write the bp7 of the port 2 output register (P2OUT) to "0".
Except P27, each bit can be set individually whether pull-up resistor is added or not, byt the port 2 pull-up
resistor control register (P2PLU). When the control flag of the port 2 pull-up resistor control register
(P2PLU) is set to "1", pull-up resistor is added. P27 is always added pull-up resistor.
Special Function Pin Setup
P20 to P24 are used as external interrupt pins, as well.
P21 is used as an input pin for external interrupt and AC zero-cross. To read data of AC zero-cross, set the
bp7 of the noise filter control register (NFCTR0) to "1" and read the value of the port 2 input register (P2IN).