Panasonic 700 Guida Utente

Section 700 - Operation

Chapter 4. Key Telephone Features

DBS-2.3/9.2-700

DBS Manual - Revised April 2000

  4-53

• If a new code is programmed into a key, the previously programmed code 

is erased.

• To erase a code programmed into a key, press the HOLD key when the 

display reads “Enter Code.” “Code Cleared” then appears on the display.

• The system can be programmed so that Pooled Trunk Access calls 

automatically use LCR when 9 is selected.

• Night Service, DND, and BGM can be activated through FF keys without 

lifting the handset.

• When you are making a call using the Speed Dialing feature, the FLASH 

key stored in Speed Dialing becomes the PBX flash feature.

• When an extension is assigned to an FF key, the FF key changes colors to 

indicate the status of the extension as follows:

-  RED (solid) -- extension busy

-  RED (flashing) -- incoming call or receiving call waiting (DSS/

72 and EM/24 keys stay solid red instead of flashing red)

-  GREEN -- either DND, call forwarding, or absence message 

set.

Voice Mail Transfer Key

(CPC-AII and CPC-B Version 
6.0 or higher)

CONF, AUTO AUTO, NNN XXX or AUTO Speed Dial

Note: If a password is used, it can be from 1 to 3 digits. If 
the password is over 3 digits, it must be assigned to a per-
sonal or system speed dial number . Include an ending # sign 
in the speed dial number if you are accessing a DBS voice 
mail system.

One-Touch VM Access

(CPC-AII and CPC-B Version 
5.0 or higher)

Note: If a password is used, it can be from 1 to 3 digits. If 
the password is over 3 digits, it must be assigned to a per-
sonal or system speed dial number . Include an ending # sign 
in the speed dial number if you are accessing a DBS voice 
mail system.

Voice mail

pilot number

Password (optional)

 AUTO NNN   XXX or AUTO Speed Dial#

Voice mail

pilot number

Password (optional)