Philips 639 Manuale Utente
82
Operator services
and select
Conference
. Repeat the above process until
five members are connected.
If there is an incoming call during the conference call
and there are less than five members, you can accept
this new call by pressing
If there is an incoming call during the conference call
and there are less than five members, you can accept
this new call by pressing
,
. Press
,
again and
then select
Conference
to add this member to the
conference call. If there is an incoming call during a
conference with five members already connected, you
can answer this new incoming call, but not add it to
the conference.
While a conference call is in progress, press
conference with five members already connected, you
can answer this new incoming call, but not add it to
the conference.
While a conference call is in progress, press
,
to
access the
Conf. members
options. Disconnect a
member of the conference by selecting
Remove party
and pressing
,
to confirm, or select
Private call
to
have a private call with this member only (other
members are put on hold).
members are put on hold).
Subscription dependent
You can connect an active call and a call on hold. You
are disconnected when the transfer is completed.
During a call press
are disconnected when the transfer is completed.
During a call press
,
, select
Transfer
and press
,
.
This feature is different from the Call forward, which
takes place before you pick up the call (see page 69).
takes place before you pick up the call (see page 69).
Explicit call transfer
Philips639_APMEA_CTA_GB.book Page 82 Saturday, February 28, 2004 2:40 PM