Exabyte 480 Manuale Utente
Chapter 3
52
Exabyte 440 and Exabyte 480
Setting the SCSI IDs
Default SCSI IDs are assigned at the factory for the library and
each tape drive. Drive blanks are assigned B (for blank). This
section describes how to view the default settings and change
them if necessary.
each tape drive. Drive blanks are assigned B (for blank). This
section describes how to view the default settings and change
them if necessary.
➤
Important
The library and tape drives must
each have a unique SCSI ID within each SCSI bus.
Because you may have multiple SCSI buses, the
library does not check for duplicate SCSI IDs. It is
your responsibility to make sure you do not assign
duplicate SCSI IDs within a SCSI bus.
Because you may have multiple SCSI buses, the
library does not check for duplicate SCSI IDs. It is
your responsibility to make sure you do not assign
duplicate SCSI IDs within a SCSI bus.
To view or change SCSI IDs:
1.
From the Configuration Menu, select Set SCSI IDs. The
following screen appears:
following screen appears:
Note:
The SCSI IDs shown are examples only; your settings
may differ. If one of the drive carrier slots contains a
drive blank, the library displays a B (for blank) instead
of a SCSI ID.
may differ. If one of the drive carrier slots contains a
drive blank, the library displays a B (for blank) instead
of a SCSI ID.
2.
To set the SCSI ID for the bottom tape drive (D4), press
>@ or
>@ until the screen displays the desired SCSI ID.
S C S I
D 4
D 3
D 2
D 1
L I B
I D s
:
0 5
0 4
0 3
0 2
0 1
↑
↓
→