Husqvarna YTH2548 Manuale Utente
6
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to insure proper tightness.
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Stan dard
wrench sizes are listed.
(1) Tire pressure gauge
(2) 3/4" wrenches
wrench sizes are listed.
(1) Tire pressure gauge
(2) 3/4" wrenches
(1) Utility knife
(2) 7/16" wrenches
(1) 3/4" socket w/drive ratch et
(1) Pliers
When right or left hand is mentioned in this man ual, it means
when you are in the operating po si tion (seated be hind the
steer ing wheel).
when you are in the operating po si tion (seated be hind the
steer ing wheel).
TO REMOVE TRACTOR FROM
CAR TON
CAR TON
UNPACK CARTON
• Remove all accessible loose parts and parts cartons
from carton.
• Cut along dotted lines on all four panels of carton.
Remove end panels and lay side panels fl at.
• Remove mower and packing materials.
• Check for any additional loose parts or cartons and
• Check for any additional loose parts or cartons and
remove.
HOW TO SET UP YOUR TRACTOR
CHECK BATTERY (See Fig. 2)
• Lift hood to raised position.
• If this battery is put into service after month and year
• If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in Maintenance section of this man u al
for charg ing instructions).
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in Maintenance section of this man u al
for charg ing instructions).
LABEL
FIG. 2
ASSEMBLY
FIG. 1
2771
STEER ING
WHEEL INSERT
WHEEL INSERT
1/2 HEX NUT
ADAPTER
STEERING
SHAFT
SHAFT
STEERING
WHEEL
WHEEL
LARGE FLAT
WASHER
WASHER
BEFORE REMOVING TRAC TOR FROM
SKID
SKID
ATTACH STEERING WHEEL (See Fig. 1)
• Remove locknut and large fl at wash er from steering
shaft.
• Position front wheels of the tractor so they are pointing
straight forward.
• Position steering wheel so cross bars are horizontal
(left to right) and slide onto steering wheel adapter.
• Secure steering wheel to steering shaft with locknut
and large fl at wash er pre vi ous ly removed. Tight en
securely.
securely.
• Snap steering wheel insert into cen
ter of steering
wheel.
• Remove protective materials from tractor hood and
grill.
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN
SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO
ROLL OFF SKID.
SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO
ROLL OFF SKID.