iHome IH24 Manuale Utente

•

  Press the Sleep Button while the iPod is playing to enter sleep mode, and continue to press to step through the available sleep 

times: 90, 60, 30 or 15 minutes. The sleep mode icon             will appear on the display. The iH24 will play for the number of 
minutes set, growing gradually softer until shutting off both the unit and the iPod at the set time. Press the Volume Up     or 
Down       controls to set your own sleep volume. Sleep volume setting is separate from your alarm or regular listening volume 
selection.

•

  Use an audio patch cord (available at www.ihomeaudio.com) to play nondocking iPod models or other audio devices 

through the iH24  Aux in Jack (one end in the device’s line out or headphones jack, the other in the iH24 Aux in jack). Make 
sure there is no iPod docked in the iH24 when using the Aux in jack. Press the           iPod Play Button.

•

  Press the 

Snooze/Dimmer Button during normal operation to adjust the brightness of LCD display. While operating on AC 

current, the switch will toggle between high, medium, low and off settings. In battery mode, the display is off by default. Press 
once to activate the display for about 3 seconds.

•

 You can disable the iH24 controls to avoid turning on the device or changing settings while in transit and to save battery life 

during extended periods of non-use. To do so, move the Travel Lock Switch         (located on the back of the unit) to the Locked 
icon position. A Lock Icon           will appear on the display indicating the unit is locked and controls are inactive. Move the switch 
to the Remote positon to restore normal function with remote control capability, or to the Off position to restore function with the 
remote disabled.

•

 Press 

the

 EXB Button          located on the back panel of the unit to enable the EXB sound enhancement circuitry. This 

circuitry is designed to provide a broader audio image with enhanced low range and mid range sound reproduction to bring  
added life to compressed MP3 files. The EXB icon            will appear in the display when EXB is active. Press button again to 
disable the EXB effect. 

4

5

Install/Replace Backup Battery
The iH24 uses a backup battery system to provide continuous alarm operation and 

clock settings in the event of a power failure. If the Backup Battery Low Icon located 

on the right of the display is flashing, it is time to replace the backup batteries. Please 

make sure the AC adaptor is connected, otherwise all settings may be lost during 

battery replacement.
Open the battery compartment cover located on the back of the unit.
 Insert 1 “CR2032” battery with the + facing out. Replace battery compartment cover. 

Battery install for

Clock display back up

The iH24 uses 4 “AA” batteries for portable playing. If sound becomes weak or 

distorted while operating on batteries, it’s time to replace the batteries.The iH24 will 

not charge iPod while operating on batteries.
•  Open the battery compartment cover located on the bottom of the unit. 
•  Insert 4 AA (LR) batteries in the compartment as indicated, making sure the 

polarity (+ and -) matches the diagram. 

•  Replace battery compartment cover.

•  Do not mix old and new batteries.
•  Do not mix alkaline, standard (carbon -zinc) or rechargeable (nickel-cadmium) 

batteries.