Philips AJ 3280 Manuale Utente

Clock display
The time is displayed using the 24-hour clock.

Adjust the SET control to the TIME position.

Press and hold down the 

4,7 buttons to set

and adjust both the hours and the minutes.
– With your finger held down on 

7, the time

will increase rapidly and continuously from
minutes to hours. Release 

7 when you

reach the approximate time setting.

– With your finger held down on 

4 will allow

you to adjust the time slowly back minute
by minute.

Release the 

7 or 4 buttons when you have

reached the correct setting.

To safeguard the clock time from being
accidentally adjusted, turn the SET control to
the RUN position.

General
If you wish to use the alarm, then you should
first set the alarm time. Two different alarm
times are possible. This can be useful when, for
example, you need to be awakened at a different
time during the week and at the weekend. There
is also the choice of two modes for waking you
up: by buzzer or radio.
The display also indicates whether you have
switched on the alarm (s), and these indicators
will light up respectively next to ALARM 1 and
ALARM 2 on the display

Adjust the SET control to the ALARM 1 or
ALARM 2 position.

Press and hold down the

4, 7 buttons to set

and adjust both the hours and minutes.

– With your finger held down on 

7, the time

will increase rapidly and continuously from
minutes to hours. Release 

7 when you

reach the approximate time setting.

– With your finger held down on 

4 will allow

you to adjust the time slowly back minute
by minute.

Release the 

7 or 4 buttons when you have

reached the correct setting.

Adjust the SET control to the RUN position to
return to clock time display.
– To review your set alarm time, adjust the

SET control to the respective ALARM 1 or
ALARM 2 position.

To select the alarm mode you wish to be
awoken by, set the respective ALARM 1 or
ALARM 2 switch to 

RAD

or 

BUZ

.

–

If you have selected the radio mode, make
sure you have adjusted the volume loud
enough to wake you up.

– The buzzer is set at a fixed volume and

cannot be adjusted.

You can switch off the alarm in three ways:
Unless you choose to cancel the alarm
completely, the ALARM RESET option will be
automatically selected after 59 minutes from the
time your alarm first goes off.

ALARM RESET
If you want the alarm mode to be stopped
immediately, but also wish to repeat the alarm
call at the same time for the following day:
• Press ALARM RESET during the alarm call.

REPEAT ALARM
This will repeat your alarm call at 6 minute
intervals
• Press 

SLUMBER OFF

/REPEAT ALARM.

• Press 

SLUMBER OFF

/REPEAT ALARM again

during the next call if you wish to repeat the
alarm call.

5

AJ3280/00 page 5