Beko DC 7100 Manuale Utente

10 EN

Make sure that you have an earthed power 

outlet socket rated at 13 amps (minimum).

When installed, the socket must be reachable 

after installation, or a separate switch (which 

can disconnect the two poles) must be used 

in the installation. Check for suitability.

For a permanent connection, a master switch 

with at least 3mm contact clearance and 

minumum 13 A rating must be used.

Before you insert the plug into the wall socket 

make sure that the voltage and the frequency 

shown in the rating label corresponds to your 

electricity supply. 

We recommend that this appliance be 

connected to the mains supply via a suitable 

switched and fused socket in a readily 

accessible position. 

Should the mains lead of the appliance 

become damaged or need replacing at any 

time, it must be replaced by a special purpose 

made mains lead which can only be obtained 

from a Authorised Service Agent. 

A 

This appliance must be earthed 

If the fitted moulded plug is not suitable for 

your socket, then the plug should be cut off 

and an appropriate plug fitted. 

The moulded plug on this appliance 

incorporates a 13A fuse. Should the fuse need 

to be replaced an ASTA approved BS1362 

fuse of the same rating must be used. Do not 

forget to refit the fuse cover. In the event of 

losing the fuse cover, the plug must not be 

used until a replacement fuse cover has been 

fitted. Colour of the replacement fuse cover 

must be the same colour as that visible on the 

pin face of the plug. Fuse covers are available 

from any good electrical store.

In order to avoid hazards, damaged supply 

cord should be replaced by the manufacturer, 

its service agent or similarly qualified people.

Built-under installation

This appliance can be installed under a 

worktop.

A

  Do not operate without the top cover 

fitted. Risk of injury.

A

As the colours of the wires in the mains lead 

of this appliance may not correspond with the 

coloured markings identifying the terminals on 

your plug, proceed as follows:

1 Connect the green - yellow or green (earth) 

wire to the terminal in the plug marked ‘E’ or 

with the symbol  or coloured green and yellow 

or green.

2 Connect the blue (neutral) wire to the 

terminal in the plug marked ‘N’ or coloured 

black.

3 Connect the brown (live) wire to the terminal 

in the plug marked ‘L’ or coloured red. 

With the alternative plugs a 13A fuse must 

be fitted either in the plug or adaptor or in the 

main fuse box. If in doubt contact a qualified 

electrician.

Do not stack washing machine on top of 

the tumble dryer. This would damage both 

appliances and guarantees would become 

void. It is also unsafe to stack an appliance 

on top of another without using a suitable 

and approved stacking kit obtained from the 

manufacturer of the appliances.

• A special stacking kit is required as an 

optional extra please contact customer 

service.

Green and yellow

or green

Blue or black

Brown or red