Maytag W10131619A Manuale Utente

1. Close the door. 
2. Select a new cycle and temperature (if desired). 
3. Push the START button.

Use the Drying Rack to dry items such as sweaters and pillows without tumbling. The drum 

turns, but the drying rack does not move.
If your model does not have a drying rack, you may be able to purchase one for your model. To 
find out whether your model allows drying rack usage and for information on ordering, please 
refer to the front page of the manual or contact the dealer from whom you purchased your dryer.
NOTE: The drying rack must be removed for normal tumbling. Do not use the automatic cycle 

with the drying rack.
To use the drying rack
1. Place drying rack in dryer.

Style 1: Your drying rack has front legs. Slide rear pegs into the dimples on the back wall of 

the dryer. Lower the front legs to rest on the dryer opening.

Style 2: Your drying rack does not have front legs. Do not remove the lint screen. Slide 

drying rack over the bottom of the dryer door opening. Push down to secure drying rack on 

frame.

2. Put wet items on top of drying rack, leaving space between items. Do not allow items to 

hang over the edge of the drying rack. Close the door.

3. Select a timed drying cycle and temperature, or an air cycle. Items containing foam, 

rubber, or plastic must be dried on a clothesline or by using an air cycle. Refer to the 

following table.

4. Start the dryer. Reset cycle to complete drying, if needed.

Washable wool items (block to shape, lay flat on 
drying rack)

Timed

 

Drying 

Low

60 min.

Stuffed toys/pillows (cotton or polyester filled)

Timed

 

Drying 

Low

60 min.

Stuffed toys/pillows (foam rubber filled)

Air 

 

(no heat)

N/A

90 min.

 

Keep dryer area clear and free from items that would obstruct the flow of combustion and 
ventilation air.

Clean lint screen before each load. A screen blocked by lint can increase drying time.

■

Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so 
can cause overheating and damage to both the dryer and fabrics.

■

If lint falls off the screen into the dryer during removal, check the exhaust hood and 
remove the lint. 

1. The lint screen is located on top of the dryer. Pull the lint screen toward you. Roll lint off 

the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard 
to remove.

2. Push the lint screen firmly back into place.

1. Roll lint off the screen with your fingers.
2. Wet both sides of lint screen with hot water.