IBM 5078 Manuale Utente
__ 10.
Connect the HSL cable from 5079–001 HSL connector 1 to HSL connector 0
on unit X. This cable should now run between 5079–001 and Unit X.
on unit X. This cable should now run between 5079–001 and Unit X.
__ 11.
Connect the SPCN cable from 5079–001 connector J16 to connector J15 on
unit X. This cable should now run between your 5079–001 and Unit X.
unit X. This cable should now run between your 5079–001 and Unit X.
__ 12.
Install the covers on unit X, your 5079, and your system unit.
__ 13.
Connecting your 5079 in the middle of a loop
Use this procedure if you are connecting your 5079 to the middle of a loop. In
other words, you are connecting your 5079 between two other expansion units.
These instructions refer to these expansion units as unit X and unit Y as is shown
in Figure 8 on page 13 and Figure 17.
other words, you are connecting your 5079 between two other expansion units.
These instructions refer to these expansion units as unit X and unit Y as is shown
in Figure 8 on page 13 and Figure 17.
__ 1.
Remove or open the back cover on unit X and unit Y. See Appendix A,
“Removing the back covers” on page 31 if you need instructions.
“Removing the back covers” on page 31 if you need instructions.
__ 2.
At unit Y remove the SPCN cable from connector J15. See Appendix B,
“Connector Locations” on page 35 if you need information about finding
connectors.
“Connector Locations” on page 35 if you need information about finding
connectors.
__ 3.
At unit Y remove the HSL cable from connector 0.
__ 4.
Open the back cover on your 5079.
__ 5.
Connect the cables to 5079–002 (the upper unit).
Figure 16. HSL connections
Figure 17. SPCN connections
24
Setting up your 0578, 5074, 5078 or 5079 Expansion Unit V5R2