RedMax TR2350S Manuale Utente

US-14

TR2350S

every

100

system/compornent

procedure

before

hours

note

use

after

fuel leaks, fuel spillage

wipe out

✔

fuel tank, air filter, fuel filter

inspect/clean

✔

replace, if necessary

see

■ADJUSTING

replace carburetor

idle adjusting screw

✔

IDLING SPEED (p.12)

if necessary

clean and readjust

GAP: .025in(0.6~0.7mm)

spark plug

✔

plug gap

replace, if necessary

cylinder fins, intake air cooling vent

clean

✔

muffler, spark arrester, cylinder exhaust port

clean

✔

throttle lever, ignition switch

check operation

✔

replace if

cutting parts

✔

something's wrong

debris guard

make sure to attach

✔

gear case

grease

✔

screws/nuts/bolts

tighten/replace

✔

not adjusting screws

ENGINE

SHAFT

■ MAINTENANCE CHART

Maintenance, replacement, or repair of the emission control device and
systems may be performed by any non-road engine repair establishment or
individual.

9. Maintenance

■ REFILLING TRIMMING LINE (MA1)
1. For replacement line, use a diameter of .095in (2.4mm). The

spool is capable for a line upto 20ft (6m) on the 4” head. Avoid
using a larger line as it may cut down the trimming
performance.

For safety reasons, do not use metalreinforced line.

2. Pinch the slotted area on the both sides of the spool housing to

unhook the bottom cap.

3. Take out the spool and pull off the old line. Fold new line so that

one half line is 4.7in.(12cm) shorter than another half. And then,
hook bended end in the slot of the spool.

4. Wind up the line in the correct direction as indicated on the

spool.

5. Hook each end of the line in the slot on the edge of the spool,

and then put the ends through the eyelets on the housing. Make
sure that the spring and the washers are in place.

6. While holding the spool against the housing, pull the line ends

to release them from the slot.

7. Line up the slot on the bottom cap with the hook on the housing,

press the cap against the housing until it clicks.

WARNING

MA1