Sigma LBA-712 Manuale Utente

 

This chapter describes how to get started using your LBA-PC.  Follow these steps: 

 

Step 1) 

Install your LBA-PC frame grabber card into your PC. 

Step 2) 

Hook up your camera. 

Step 3) 

Turn on the system and setup your windows environment. 

Step 4) 

Launch the LBA-PC windows application. 

Step 5) 

Configure the LBA-PC for your camera type. 

Step 6) 

Begin collecting data from your camera. 

Step 7) 

Other Configurations 

 
Note:  If you purchased your LBA-PC from Spiricon with a computer system and installation, then steps 1, 3, and 5 
will have been done for you, and you can skip those steps. 
 

This installation procedure applies to the following Spiricon products:   
 LBA-300PC 
 LBA-400PC 

(-D) 

 LBA-500PC 

(-D) 

 LBA-7XXPC 

(-D) 

 LBA-PC-PIII 
 

CAUTION 

Electrostatic Discharge can result in permanent damage 

to electronic equipment.  Always ground yourself by 

touching the system cabinet before beginning the 

following procedure.  We strongly recommend using an 

antistatic wrist strap attached to earth ground. 

 

To install your LBA-PC frame grabber card, disconnect the AC power from your computer.  Remove 

the cover from your computer as described in your computers technical manual.  Locate your PCI bus 
slots.  Most PC’s will have either 3 or 4 PCI slots.  Select an unused PCI slot and remove the rear filler 

bracket associated with that slot.  (See figure below) 
 

Operator’s Manual 

 

LBA-PC 

 

Doc. No. 10654-001, Rev 4.10 

15