Toshiba CS3950DIF Manuale Utente
6
Documents No. D4134648A
5. Functions
•
••
• Gain Control
This camera adopts the manual gain setting method. The factory setting is 0dB (rated image pickup
state). By adjusting the setting value of the command status register of the camera via the IEEE1394
serial bus, you can set the gain in 121 steps in the range between −6 to +10dB. However, the amount
of gain change per step is not constant because of the variable characteristic of the gain control
amplifier.
state). By adjusting the setting value of the command status register of the camera via the IEEE1394
serial bus, you can set the gain in 121 steps in the range between −6 to +10dB. However, the amount
of gain change per step is not constant because of the variable characteristic of the gain control
amplifier.
•
••
• Shutter mode switching
You can switch the shutter modes by adjusting the setting value of the command status register of the
camera via the IEEE1394 serial bus.
camera via the IEEE1394 serial bus.
Normal electronic shutter
: Performs exposure control via the internal synchronization signal.
Random trigger shutter
: Random trigger shutter can capture images at any timing using the external
trigger signal and soft trigger input. It is effective for image input of moving
objects and obtaining images of the same timing using multiple cameras.
objects and obtaining images of the same timing using multiple cameras.
•
••
• Normal electronic shutter and Random trigger shutter exposure switching
You can switch the exposure mode of the electronic shutter by adjusting the setting value of the
command status register. This camera supports Trigger mode 0 and Trigger mode 1 of the IIDC1394
digital camera protocol. You can switch the exposure mode of the random trigger shutter by
adjusting the setting value of the command status register.
command status register. This camera supports Trigger mode 0 and Trigger mode 1 of the IIDC1394
digital camera protocol. You can switch the exposure mode of the random trigger shutter by
adjusting the setting value of the command status register.
FIX mode
: The following exposure time can be set via the IEEE1394 serial bus;
1/100s, 1/250s, 1/500s, 1/1,000s, 1/2,000s, 1/4,000s, 1/10,000s, and
1/20,000s
32bit Floating-point format mode :
The following exposure time can be set via the IEEE1394 serial bus;
Exposure time: 10µs ~ 2s
Exposure time = (-1)** S * (M+1) * 2** (E-127) [sec]
Sign (S)
Exponent (E)
Mantissa (M)
1bit
8bit
23bit
Pulse width mode(Only Random trigger shutter)
: The exposure time can be controlled by the TRIG signal pulse width.
Pulse width : 1µs ~ 2s
•
••
• Video output mode
1/30s non-interlace mode
All pixels are read in 1/30s, so video image in high vertical resolution can be obtained.
All pixels are read in 1/30s, so video image in high vertical resolution can be obtained.