Toshiba IK-DF01A Manuale Utente

- 4 -

1:BLC (Backlight Compensation Control)

When switched on, it 
automatically adjusts to 
compensate for subjects that 
are lit from behind.

2:AGC (Auto Gain Control)

When switched on, it 
automatically adjusts the 
image in relation to the 
brightness of the subject.

3:DC/AES

Not available for this camera.
Be sure to switch to ON.

4: LL (Line Lock)

Use this switch to set the 
camera synchronization to 
internal or line lock.  Line 
Lock is available with AC24V 
only.

Installs camera to ceiling with 
attached screws.

Turn the ring-type screw to adjust the lens pan angle. 
Fasten and lock it after completing the adjustment.

Turn the screws to adjust the lens tilt 
angle. Fasten and lock them after the 
adjustment completes.

Cut with a knife or scissors 
and insert the cables through 
the knockout so the cables will 
not pinched when installed.

The "Bottom" mark indicates the 
lens position.  The "Bottom" mark 
should be on the top when installing 
in a ceiling.

Adjusts the image into focus.  Its screw 
design allows locking capability.

Use to compensate 
for the iris level.
Turn towards L (low) 
for a darker picture.
Turn towards H (high) 
for a brighter picture.
Optimum value is 
adjusted at the 
default setting.

Adjusts the phase 
difference between 
this camera and other 
cameras when in Line 
Lock mode.

Connect the power 
cable to AC24V or 
DC12V. (RED:+12, 
Black:GND)

Connect the Video Cable to 
a monitor or video device.
The image is outputted 
when powered on.

Changes the picture range.
Its screw design allows 
locking capability.