Toshiba IK-WB21A Manuale Utente
53
Viewing
・
Listening
and Operation
Set up
Recording
Others
Introduction
52
Viewing
・
Listening
and Operation
Set up
Recording
Others
Introduction
Recording Images in SD Memory Card (Cont.)
4
Configure each setting items.
■ Alarm Recording
● Alarm In
ON: Images are recorded when an external alarm occurs.
OFF: Images are not recorded when an external alarm occurs.
OFF: Images are not recorded when an external alarm occurs.
● Ext. Control In
ON: External control recording is performed.
OFF: External control recording is not performed.
OFF: External control recording is not performed.
● Motion Detection
ON: Images are recorded when motion is detected.
OFF: Images are not recorded when motion is detected.
OFF: Images are not recorded when motion is detected.
● Pre-Recording
Set the number of images to be recorded immediately before an alarm
occurs. Images of the moment when an alarm occurs are not included.
occurs. Images of the moment when an alarm occurs are not included.
● Post-Recording
Set the number of images to be recorded immediately after an alarm
occurs. Images of the moment when an alarm occurs are not included.
occurs. Images of the moment when an alarm occurs are not included.
● Recording cycle
Set a time interval for alarm recording.
■ Continuous Recording
ON:
Images are recorded in accordance with schedule and recording in-
terval.
Setting to ON will set a recording schedule and interval.
OFF: Continuous recording is not performed.
■ Overwrite
ON:
Records are overwritten beginning with old records when the capac-
ity of the SD memory card becomes full during recording.
OFF: Recording is stopped when the capacity of the SD memory card be-
comes full during recording.
5
Click the Save button under the items.
･ Changes are saved.
NOTE
●
Clicking the Reset button under each item resets to the setting last saved.
●
Clicking the Default button resets settings back to factory default.
●
The total number of recorded frames per alarm will be the number of pre-
alarm images + One image when alarm occurs + Number of post-alarm images
alarm images + One image when alarm occurs + Number of post-alarm images
●
To enable "Alarm In", see the "Camera/Alarm Settings" on page 73.
●
To enable "Ext. Control In", see the "Camera/Alarm Settings" on page 73.
●
Setting the Overwrite mode to ON deletes files beginning with old files. If
important data is to be saved, set the Overwrite mode to OFF.
important data is to be saved, set the Overwrite mode to OFF.
●
Getting a record list of the SD memory card sometimes takes more than 5
minutes after turning the power on. Data cannot be recorded while obtaining
a record list.
minutes after turning the power on. Data cannot be recorded while obtaining
a record list.
●
The camera recording period may not operate as set depending on the type
of the SD memory card.
of the SD memory card.
Deleting Record File
Image files recorded in an SD memory card can be deleted.
1
Click "Camera Settings" in the Admin. Menu.
･ A sub menu for Camera settings will appear.
2
Click "Recording" in the sub menu.
･ A setup screen for Camera/Recording will appear.
3
Click "Delete all", "Delete from Alarm Recording list...",
"Delete from Continuous Recording list..." or "Delete
from Ext. Control In Recording list..." in Recorded
Files.
"Delete from Continuous Recording list..." or "Delete
from Ext. Control In Recording list..." in Recorded
Files.
･ Clicking "Delete all" deletes all record files.
･ Clicking "Delete from Alarm Recording list..." displays an alarm list.
･ Clicking "Delete from Alarm Recording list..." displays an alarm list.
Specifying a range for deletion deletes alarm record files.
･ Clicking "Delete from Continuous Recording list..." displays a normal
list. Specifying a scope for deletion deletes normal record files.
･ Clicking "Delete from Ext. Control In Recording list..." displays an
external control record list. Specifying a scope for deletion deletes
external control record files.
external control record files.