Nikon 1541 Manuale Utente

337

U

Selecting Yes allows adjustments that are normally made by 
holding the I (Q), E, D, M, Y, S, T, U, or AF-mode 
button and rotating a command dial to be made by rotating the 
command dial after the button is released (this also applies to the 
Fn

 and Pv buttons and the Fn button for vertical shooting, if they 

have been assigned Active D-Lighting using Custom Setting f3, 
Assign Fn button; 0 328, Custom Setting f4, Assign preview 
button; 0 333, or Custom Setting f7, Assign Fn button (vert.); 
0 334). Setting ends when any of the affected buttons is pressed 
again or the shutter-release button is pressed halfway. Except 
when No limit is selected for Custom Setting c2 Standby timer, 
setting will also end when the standby timer expires.

If Off is selected, the multi selector is used to choose the 
picture displayed during full-frame playback, highlight 
thumbnails, and navigate menus. If On or On (image review 
excluded) is selected, the main command dial can be used to 
choose the picture displayed during full-frame playback, move 
the cursor left or right during thumbnail playback, and move 
the menu highlight bar up or down. The sub-command dial is 
used to display additional photo information in full-frame 
playback and to move the cursor up or down during thumbnail 
playback. Select On (image review excluded) to prevent the 
command dials from being used for playback during image 
review.  While menus are displayed, rotating the sub-
command dial right displays the sub-menu for the selected 
option, while rotating it left displays the previous menu. To 
make a selection, press 2, the center of the multi selector, or 
J.

G

 button ➜ A Custom Settings menu