Canon XL H1S Manuale Utente

54

You can synchronize this camcorder’s time code to an external time code generator. You can also 
include in the recording the user bit signal received from the TC-IN terminal (

56). The camcorder 

offers the following synchronization options.

When a reference sync signal (analog blackburst or tri-level signal) is input through the GENLOCK terminal, 
the V and H phases of the camcorder’s time code will automatically be synchronized to it.

An external SMPTE-standard LTC timing signal received from the TC-IN terminal will be recorded as the time 
code on the tape. The user bit of the external timing signal can also be recorded on tape.

The camcorder’s internal time code is sent out from the TC-OUT terminal as a standard LTC timing signal.
When [SIGNAL SETUP]   [SDI OUTPUT] is set to [ON(OSD)] or [ON], the time code signal will be output also 
through the HD/SD SDI terminal.

* In SD mode, Time Code IN is not available if you select the 24F frame rate (the mode will be canceled and the 

“TC·IN” display on the side panel will disappear).

* As a reference video signal input you can use either an HD Y signal or an NTSC composite video signal.

 While a time code signal is being received, the [FRAME SETTNG] and [COUNT-UP] settings of the 

camcorder will be ignored and the external time code’s drop-frame bit will be used instead (if the 
external time code is non-drop frame, “NDF” will appear on the side panel).

 The Genlock synchronization stabilizes after approx. 10 seconds. After that, the synchronization 

will be maintained even if you disconnect the cable from the GENLOCK terminal.

–

–

–

–

–

–

–

Reference video 
signal*

SMPTE-standard 
LTC timing signal

Genlock

Time Code IN

CO

PY