Canon HG10 Manuale Utente
65
Photos
Refer to this chapter for details on shooting photos – from capturing
and playing back images to printing them.
and playing back images to printing them.
Taking Photos
1
Move the
/
switch to
(Still
images).
2
Turn the
switch to ON to set
the camcorder in CAMERA mode.
The red CAMERA indicator will turn
on.
on.
3
Press
halfway.
• Once the focus is automatically
adjusted,
will turn green and
one or more AF frames will appear.
• When you press
on the
wireless controller, the still image is
recorded immediately.
recorded immediately.
4
Press
fully.
The CARD access indicator will flash
as the still image is being recorded.
as the still image is being recorded.
IMPORTANT
Observe the following precautions while
the card access display (
the card access display (
) appears
on screen, and when the CARD access
indicator is on or flashing. Failing to do so
may result in permanent data loss.
- Do not subject the camcorder to
indicator is on or flashing. Failing to do so
may result in permanent data loss.
- Do not subject the camcorder to
vibrations or strong impacts.
- Do not remove the memory card.
- Do not disconnect the power source or
- Do not disconnect the power source or
turn off the camcorder.
- Do not change the position of the
/
switch or the operating mode.
NOTES
• If the subject is not suitable for
autofocus,
turns yellow. Adjust the
focus manually (
56).
• When the subject is too bright,
“OVEREXP.” starts flashing. In such
case, use the optional FS-43U II ND
filter.
case, use the optional FS-43U II ND
filter.
Recording
Before using a memory card for the first
time, be sure to initialize it with this
camcorder (
time, be sure to initialize it with this
camcorder (
76).
(
24)
PHOTO
PHOTO
PHOTO
D122_NTSC_E.book Page 65 Thursday, July 19, 2007 6:43 PM